Adjusting motor mount on mini bike chopper

#ADJUSTING MOTOR MOUNT ON MINI BIKE CHOPPER HOW TO#

Take out the hsn on the carb side and dont lose the thin washer, metal spring or small rubber-o-ring attached to it. Its set tight with epoxy and must be reset with 1hour set epoxy again to prevent the setting from wandering from harsh engine vibes while giving time for finetune adjustments if needed when you get it running.

#ADJUSTING MOTOR MOUNT ON MINI BIKE CHOPPER HOW TO#

Also, have a new plug in it and fresh fuel and 2 cycle oil mixed at 1:32 ratio.ДЄnybody know what I am doing wrong? Or how to fix the fuel flow? I installed the black tube on the curved supply fitting and the clear tube on the straight return fitting. OTHER NOTES: When I got the mini chopper the primer bulb was destroyed so I bought and installed a new carb (15mm venturi opening) and fuel line kit with filter stone last month. If I remove the line after priming (without trying to start) the fuel flows out of the line. NOTE: Attempting to start seems to be what kills the flow. I end up repeating this process of trying to start, losing fuel flow, and applying suction to get fuel flowing to the carb again.

I get fuel flowing to the carb again by applying suction with a straw to the fuel line and immediately attaching it to carb. It will run for only 30 seconds by using starting fluid and then stalls.ДЄfter trying to start (pull cord or electric) I lose fuel flow to the carb. My 43cc APC Mini Chopper (well it might be a chinese clone) seems to have a fuel flow problem.

Adjusting motor mount on mini bike chopper